1 Function Replacement FET Receiver | 9 Series

This is a replacement FET receiver for Lodar 9 Series wireless control systems — 1-function, FET (solid-state) output switching rated to 10 A per output. The receiver mounts on the equipment, receives the signal from the transmitter, and switches the output functions. Includes a master output — an additional output that fires on every function: once wired in, it energizes whenever any function is operated, for equipment that must run in conjunction with the controls (a hydraulic power unit running while a lift function operates, a safety light while winching).

Replacement part for an existing Lodar 9 Series wireless system — a receiver is not a standalone product. It pairs with a matching transmitter on the same series and function count.

Momentary or latched — pick by output

The 1-function receiver gives you both output behaviors: the F1 output (green wire) is momentary — live only while the button is pressed — and the F2 output (yellow wire) is latched — press once for on, press again for off. Wire your equipment to whichever output gives the behavior you need.

FET or Relay receiver — which do I need?

Match what your existing system uses. A 9 Series FET receiver switches outputs with solid-state transistors — no contacts to wear, well suited to high-cycle operation — and is rated to 10 A per output. Relay receivers switch with electromechanical relays and are rated to 5 A per output. That amp rating has a practical consequence: if any function on your system draws more than 5 A, you need the FET receiver. The two are not interchangeable in a system; replace a FET receiver with a FET receiver.

• 1-function FET receiver
• For Lodar 9 Series wireless control systems
• F1 output (green wire) momentary, F2 output (yellow wire) latched
• Master output — an additional output that fires on every function
• DC FET output switching · 10 A · 12/24V DC · Wide Band
• Lodar SKU 9201RX

Match the trailing code. Lodar 9 Series transmitters and receivers carry a trailing match number. Check the unit you are replacing: no number means -8, the most common code we carry, and some systems use -3. If your existing system or part is coded anything other than -8, contact us so we send the correct unit.

This is a replacement part — it goes on the 1-function 9 Series wireless system. See the complete 1 Function Standard Wireless Control System. Pair it with the matching 1 Function transmitter on the same system.